6
4.
Preparing for installation
Unpack the fixture and inspect it to ensure that it has not been damaged during
transport.
The fixture is shipped with two quarter-turn brackets, that can be used to
mount the fixture at elevation.
The fixture is IP55-rated, and is designed for use in wet locations. This means
that it is protected from:
Dust, to the degree that dust cannot enter the fixture in sufficient
quantities as to interfere with its operation.
Lower pressure jets of water from any direction.
When selecting a location for the fixture, ensure that:
It is situated away from public thoroughfares and protected from contact
with people.
It is not immersed in water or exposed to high-pressure water jets.
It has adequate ventilation.
5.
Installation
The fixture may be installed in any orientation, but if installed horizontally with
a downward beam-angle, water can potentially pool in the fan wells. Under
normal operation the moisture will evaporate. However, in locations with high
rainfall, you may wish to fabricate a rain shield above the fixture, or modify the
position and orientation of the fixture to minimize pooling.
For permanent installation on the ground, remove the rubber feet from the floor
stand/ base. Fasten securely through the resulting holes with four
corrosion-
resistant mechanical fasteners suitable for the location.
11
The DMX address can be seen on the main screen. To change the address
setting, press the up arrow to increase the address, or the down arrow to
decrease the setting. When the desired address is displayed, press Enter to
save the setting.
Note that channel spacing is determined by the DMX mode.
See the “DMX protocols” on page 13 for specific DMX control values.
Setting the DMX mode
Using the “DMX mode” menu available from the control panel, specify the DMX
mode that provides the fixture controls that you require, confirm chosen mode
by pressing ‘Enter’.
10.
Cleaning
To maintain optimal performance, regular cleaning is essential. Cleaning
schedules will vary depending on the operating environment, and the
installation should therefore be checked at frequent intervals within the first
few weeks of operation to see whether cleaning is necessary. This procedure
will allow you to assess cleaning requirements in your par- ticular situation.
Clean the fixture using a soft cloth dampened with a solution of water and a
mild detergent. Do not use products that contain solvents, abrasives or caustic
agents for cleaning, as they can cause damage to both hardware, cables and
connectors.
