Artesyn AXP1440, Installation And Use Manual, Page: 109 / 156

Chapter 6
AXP1440 Installation and Use (6806800H23U) 107
FRU Installation
6.1 Overview
The following sections help you to start up and maintain the system:
Installing RTMs, Blades and SAMs on page 107 , describes the steps needed to install
and remove RTMs, AdvancedTCA blades, and shelf management alarm modules.
Unused Slots on page 119 , provides information how to cover empty slots.
Installing Power Entry Modules on page 119 , describes the steps needed to install
and remove Power Entry Modules.
Upper and Lower Fan Tray Modules on page 122 , provides information about how
to install and remove upper and lower fan trays.
Replacing the Fan Filter on page 125 , provides information about how to install and
remove an air filter.
6.2 Installing RTMs, Blades and SAMs
The following sections provide the information needed to install RTMs, AdvancedTCA blades,
and SAMs.
6.2.1 Module Installation and Removal
The RTM can be installed into a powered or non-powered system providing its front blade is
powered down.
Product Damage
Installing the RTM with other blades than the ones designed for it may damage the RTM
and the front blade.
Only install the RTM with the correct front blade.
Use ESD
protection
Damage of Circuits
Electrostatic discharge and incorrect RTM installation and removal can damage circuits
or shorten their life.
Before touching the RTM or electronic components, make sure that you are working in
an ESD-safe environment.