Artesyn Embedded Technology ATCA-7490, Installation And Use Manual

Page: 23 / 372

ATCA-7490 Installation and Use (6806800U11F)
23
About this Manual
Overview of Contents
This guide is intended for users qualified in electronics or electrical engineering. Users must
have a working understanding of Peripheral Component Interconnect (PCI), AdvancedTCA®,
and telecommunications.
The manual contains the following chapters and appendices:

About this Manual on page 23 , lists all conventions and abbreviations used in this manual
and outlines the revision history.

Safety Notes on page 29 , lists safety notes applicable to the blade.

Sicherheitshinweise on page 33 , provides the German translation of the safety notes
section.

Introduction on page 39 , describes the main features, mechanical data, and ordering
information of the blade.

Hardware Preparation and Installation on page 45 , outlines the installation requirements,
hardware accessories, switch settings, installation and removal procedures.

Controls, Indicators, and Connectors on page 67 , describes external interfaces of the blade.
This includes connectors and LEDs.

BIOS on page 183 , describes the features and setup of BIOS.

Functional Description on page 89 , describes the functional blocks of the blade in detail.
This includes a block diagram, description of the main components used and so on.

Maps and Registers on page 107 , provides information about the maps and registers of the
blade.

Serial Over LAN on page 251 , provides information on how to establish a serial-over LAN
session on your blade.

Supported IPMI Commands on page 259 , lists all supported IPMI commands.

IPMI Feature Set on page 309 , provides information about controlling via IPMI.