Artesyn Embedded Technology ATCA-7490, Installation And Use Manual

Page: 107 / 372

Chapter 5
ATCA-7490 Installation and Use (6806800U11F)
107
Maps and Registers
5.1 FPGA Registers
For register description, the conventions shown in Table 5-1 and Table 5-2 are used.
Table 5-1 Register Default
Default Description
- Not applicable or undefined
0 or 1 Default value after PWR_GOOD is valid or after PCH_PLTRST_
deassertion.
Undef. Undefined value
<reset>: 0 or 1 Default value after deassertion of the reset signal <reset>
Ext. External Reset Source. Default depends on external logic level.
Table 5-2 Register Access Type
Access Description
r Read only
w Write only
r/w Read and write
w1c Write-1-to-clear, ignore bit while reading
r/w1c Read and write-1-to-clear, write 0 has no effect
r/w1s Read and write-1-to-set, write 0 has no effect
r/w1t Read and write-1-to-toggle, write 0 has no effect
LPC: The prefix “LPC:” signals that the access is restricted to the LPC interface.
For example, LPC: r/w means that the register bit is readable/writable from the LPC
interface
IPMC: The prefix “IPMC:” signals that the access is restricted to the IPMC I2C interface.
For example, IPMC: r/w means that the register bit is readable/writable from IPMC I2C
interface