Artesian Spas PLATINUM ELITE, Owner'S Manual

Page: 18 / 76

12
TURNING THE POWER ON
Turn the power to the spa on at the main circuit breaker. Verify that your
spa has no messages. Verify that there is good water circulation in the
spa. The pumps will come on in cycles, for 1 minute each cycle.
TESTING THE GFCI BREAKER
NOTE: The electrical service panel for your spa should be equipped
with a GFCI breaker. To avoid the risk of electrical shock, perform
the following safety test before each use of your spa.
1) Make sure the power is turned on at the electrical service panel.
2) Turn on the GFCI breaker. If the breaker stays on, it is functioning
properly.
VERIFYING WATER CIRCULATION
1) Open all the jets.
2) Press the Pump 1 key to turn the pumps on or off.
3) Make sure each seat has water flow. Note: On certain spas there is
a diverter valve. Verify where the diverter valve is located.
NOTE:
When power is turned on, your spa is automatically
programmed to start circulating water through the circulation
pump. Each pump and/or blower will come on consecutively
for approximately 1 minute to automatically purge the system.
Adjust your temperature by pressing the up button on your
touch pad until the desired temperature is displayed. This set-
ting will allow your spa to heat to the set temperature.
DANGER: RISK OF ELECTRICAL SHOCK
If the GFCI breaker fails to operate as described, there is a possibility
of an electrical shock if the spa is used. Shut off the power at the main
electrical service panel until the source of the problem has been identi-
fied and corrected by a licensed electrician or qualified spa technician.
SPA START-UP