Artel DigiLink DLC910, Installation And Operation Manual

Page: 22 / 28

12 DLC910 Function Module Installation and Operations Manual
DLC910 Function Module
Using DL Manager
This section shows how to use DL Manager to view the module’s current configuration, major and minor alarm
status, and the status of SFP A and B.
Prerequisites
To monitor the DLC910 module using DL Manager, you must access the DL Manager that manages the
module. For details about accessing and setting up DL Manager, see the DigiLink Manager Setup and
Operations Manual .
To monitor the DLC910 module operation, perform the following steps:
1. From a browser window, enter the IP address of the DL Manager that manages the module.
The Home page displays.
2. From the Home page menu bar, click Shelf View .
The Shelf View page displays, which shows the rear chassis panel along with the Installed Modules table.
3. From the Installed Modules table, click the
DLC910
link listed in the Module Type column.
The Module Status page displays, which shows the following information:
HD
Table 4. Module Status Page
Pane Field Description
Input Configuration
(Quadrants 1 to 4) Source Configured operating mode: Receiver or Transmitter
Format Configured video format: HD, SD, or 3G
Video Alarms Configured operating state: Enabled or Disabled.
On Screen Display Configured text to display.
Output Configuration View Configured output view: Quad, Full 1, Full 2, Full 3, Full 4.
Format Configured format: 1080P, 720P, 1080I
Frequency Configured frequency: 50 or 59.94
Alarms Major Alarms Detected major alarm status of monitored entities as follows:
• Green—No alarms detected.
• Red—Alarm detected that requires immediate attention.
When the alarm indicator is red, DL Manager provides a
descriptive list of any detected alarms to indicate the
source of the problem.
Minor Alarms Detected minor alarms (if any).