ARTE ©
fireplace
|COSY LINE
I
NSTALLATION MANUAL
&
USER GUIDE
15
•
FAILURE/ALARM SIGNALS
The controller can signal the failure of the probe.
The blinking message for the failure signal:
o
Lo
: indicates a low temperature (temperature under 0
o
):
Probe is Open or Disconnected
.
o
Hi
: indicates a high temperature (temperature over 180
o
):
Probe is in short circuit
15.
Cleaning and maintaining the fireplace
When performing maintenance on the fireplace, always protect yourself, using safety
goggles and gloves.
Before cleaning the fireplace, ensure that the fireplace is completely cold. The person who cleans the
fireplace must be an adult who has already read this manual.
••••
External maintenance
The fireplace surface is painted with heat-resistant paint. It is best kept clean by vacuuming with a soft brush
attachment or by wiping with a lint-free cloth. Over a period of time, the painted surface may become
slightly grey. A canister of touch-up ARTE
®
spray paint should be available from your fireplace supplier. This
can be applied - in accordance with the instructions - in just a few minutes. When first firing, after touching
up, the fireplace will give off a slight smell as the paint cures. Make sure to ventilate the room well during this
phase.
••••
Internal maintenance
Ash disposal
The easiest cleaning method is to push the ash into the ash box at the middle of the combustion chamber
of the fireplace with a dry and soft broom.
When the ash is shaken down into the ash box then extract the ash box from the combustion chamber (the
ash must be removed from the combustion chamber frequently). The ash box is most easily emptied by
pulling a waste bag over the box, turning it upside down.
Never empty a fireplace while in use. Never use your household or shop vacuum cleaner
to remove ash from the fireplace. Always remove and dispose of the ash properly.
Glass
Clean the glass with a soft piece of cloth wiped in the ashes and then rubbed on the dirty glass. The internal
glass surface from the door can be cleaned if you open it with a hex screw driver as Fig. 29 shows.
Never use abrasive cleaners on the glass surface.
Reasons for the presence of dirt on the glass
Firewood is too wet
Logs are too large or not split
Combustion temperatures are too low
To reduce the risk of breaking the glass, avoid striking the glass or slamming the door.
Replace broken glass IMMEDIATELY. Do not operate the fireplace if the glass in the door
is damaged.
Pic. 10.2.1.4
!!!!
!!!!
!!!!
