ARTDEV AS-2350, User Manual

Page: 12 / 94

6
2-4 Introduction to installation
Note: If any of the below operation is incorrect, turn off the power immediately and check the imager for
any improper connections. Go through all steps again.
2-4-1 Installation - RS-232
1) Connect the RS-232 interface cable to the bottom of the imager.
2) Connect the other end of the interface cable to the serial port on the host. Tighten the two screws
to secure the connector to the port.
3) If the host does not have power supply (on PIN 9), connect the external power supply (DC adapter)
to the RS-232 cable.
Figure 2-3
2-4-2 Installation - USB
The imager attaches directly to a USB host, and is powered by it. If the power supply is not enough,
plesae add additional power.
1)
Connect the USB interface cable to the bottom of the imager.
2) Plug the series A connector in the USB host, or an available port of the terminal.
3) Windows will automatically detect the USB device.
Figure 2-4