CHANGING DATA OR TEXT THROUGH THE KEYPAD
1) Enter the following sequence at the keypad to activate keypad programming mode:
[ * & 0 ] + [ I I I I ] + [ 9 ]
[ * & 0 ]
= Pressed simultaneously
[ I I I I ]
= Installer's code (factory default = 7777)
programmed into control panel.
2)
When you enter programming mode you will be at location 0. This is indicated by the top
line in the display saying PROGRAM# followed by #0 the actual memory location. The current
data in that address is displayed at the left on the second line of the display after you press
[ # ]
.
3)
Using the
[ * ]
key you can switch the cursor back and forth between the "program#" value
and the "data" value. To change the memory location put the cursor on the "program#" value
using the
[ * ]
key and enter a new three digit memory location, i.e. ("012" = 12). To change
the data put the cursor on the data value using the
[ * ]
key and then enter new data .
4)
The programming defaults for the domestic SK1L are shown in Figure 2. This programming
shows the locations and range of data that each memory location will accept. The keypad map
(Figure 1) shows which keys correspond to the Alpha-Numeric characters used in text
programming.
5)
While in "data" mode for locations 0 or 1, enter numbers using the number keys. For
programming Alpha-Numeric locations, each number key will enter that number and 3
different characters. Refer to (Figure 1). Pressing a key repeatedly will cause it to step through
these characters in sequence then repeat the sequence. Press the key as many times as you
need to get the character you want showing in the display on line 2. When you have the
character you want use the
▲
key to move the cursor to the next position. Once you have
the complete word showing in the display, press
[ # ]
to save that word and move on to the
next memory location.
6)
While entering or editing data the following keys can be used to reposition the cursor.
▲
move right
▲
move left
▲
up one line
▲
down one line.
If you need to clear the line or clear one character the following keys are used.
[ 1 & 3 ]
simultaneously to clear line
[ 4 & 6 ]
simultaneously to delete current character
7)
To exit keypad programming press
[ * & # ]
simultaneously
8)
The panel is now in normal mode and will operate as a control panel. You must use the
correct keypad number when in partitioned mode to assign the keypad to the partition you
intend.
The above procedure specifies keypad programming only. The SC800/1600 installation
manuals (P/N 64812821) cover panel programming functions, locations, and partition-
ing mode. Refer to the SC800 /1600 installation manuals and the SK1L owner's manual
(P/N 64812819) for information on WARRANTY and LIMITATION OF LIABILITY.
FIGURE 1 Character map for programming
Alpha-Numeric descriptions using the SK1L
keypad.
3