1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3
Install 4 roof panels in the
sequence and positions shown on
previous page. Do not fasten the
lower end of the panels to the side
wall angles at this time. Continue
weather stripping the ridge opening.
Fasten roof panel overlaps not used
for ridge cap (roof center). Cover the
head of bolt with the 2" (5,1 cm) piece
of weather stripping tape.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 14
B27 ctr
Parts Needed For
Roof Assembly
8467 Left Roof Panel (2)
7875 Roof Panel (4)
8466 Right Roof Panel (1)
2
Cut 2 short 2" (5,1 cm) strips off
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
FRONT
Do not fasten
at this time
Cut
Weather Stripping
and Fold Under
FRONT
Fasten At
Overlap with
Bolt
7875 Roof Panel
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
Weather Stripping
Tape Roll
8467 Left Roof Panel
STEP
2
STEP
Strips
STEP
Screws To
Roof Beam
8466 Right
Roof Panel
1
3
(38)
(23)
27
Summary of Contents for 697.76095
Page 2: ......
