6
VIP5662W Wireless IPTV Receiver Installation Guide
Wireless Connection
As shown in the diagram below, programs and services for the VIP5662W are transmitted
over the air from a wireless Access Point. The Access Point, in turn, is connected to your
home network gateway device.
The Access Point can transmit separate programming streams to as many as five wireless
IPTV Receivers. The Access Point uses Wi-Fi Protected Setup (WPS) protocols to identify,
authorize, and manage traffic to and from its client devices.
Register the TV Receiver with the Access Point
Before your TV Receiver can receive any programming, it must be registered as an
authorized device with the Access Point. Run the WPS procedure as follows:
1. Connect the cord from the DC Power Adapter to the POWER +12VDC connector
on the rear of the VIP5662W, and plug the adapter into an
AC wall socket. Then connect the VIP5662W to your TV
set.
2. The POWER button on the front of the wireless TV
receiver lights green to indicate power is applied.
3. Ensure that the Access Point is connected to your home
gateway device, and that power is applied to it.
4. When the TV Receiver starts up, it will look for a signal
from an Access Point. When it detects the signal, a
prompt will appear on your TV screen asking if you wish to
connect.
5. On the remote control unit, press the
OK
or
Select
button.
6. On the Access Point, press and hold the WPS button on
the front panel for two seconds, then release to activate
the WPS process.
7. An icon appears on the TV screen, indicating that the connection sequence
is in process. When three horizontal dots appear, the connection
has been successful.
8. On the front panel of the VIP5662W, two or more bars on the signal
strength indicator should light green. You have now established a
secure wireless connection between the Access Point and your
VIP5662W.
NOTE: To install additional wireless TV receivers, repeat steps 1-7.
Wireless
Access Point
