Physical Installation
12
Physical Installation
To Secure the Fixture and Accessories against Falling
Pass the safety cable through the safety loop attachment (14) of
the fixture (see picture on the right) and around the structure sup-
porting the fixture. The safety loop attachment is designed as a
shock absorber. It absorbs the forces acting on the fixture in the
event of a fall and protects the fixture from damage.
Keep the safety cable as short as possible, but as long as neces-
sary. The upper handle (3) or the focus handle (18) must not be
used as an anchor for the safety cable.
The upper handle (3) may be used as an anchor point for the safe-
ty cable for optical accessories.
Risk of falling! Risk of injury.
Attach an approved safety cable to secure the product and accessories against clamp or bracket
failure when the product is mounted above floor. The safety cable needs to be approved at least 10
times the weight of the product including all accessories mounted at the product. The safety cable
must comply with EN 60598-2-17 Section 17.6.6 and be approved by an official body such as TÜV.
Lead the safety cable through the safety loop attachment (14,see “Overview” on page 11) and the
structure the fixture is mounted to.
Keep the safety cable as short as possible, but as long as necessary. The upper handle (3) or the
focus handle (18) must not be used as an anchor for the safety cable.
The rigging structure needs to be approved for the weight of all devices, equipment and cables in-
stalled on it.
Block access below the work area and work from a stable platform whenever installing, servicing or
moving the product or accessories.
There is a danger of crushing your fingers when mounting and dismounting the yoke. Wear suitable
protective gloves if necessary.
WARNING!
Do not illuminate the product by high power light beams from a short distance. The display and the
light engine are damaged by high brightness and heat radiation within very short time.
NOTICE