ARRI L Series, User Manual, Page: 23 / 52

DM
X cont
rol
23
• Press the - / [down] button to set the DMX mode.
The JUMP menu closes 3 sec. after the last key press or after
pressing the ENTER button.
Demo mode
In demo mode the L10 calls up an endless loop with all features
the L10 supports.
• ARRI L10-TT and ARRI L10-DT: Change of the color tem-
perature from warm to cold and vice versa. Set the intensity
with the dimmer knob. Set the speed with the CCT knob from
0-100% (60 s - 1 s).
• ARRI L10-C: Call up the color spectrum or change the color
temperature from warm to cold and vice versa. Set the inten-
sity with the dimmer knob. Set the speed with the CCT knob
from 0-100% (60 s - 1 s). The GN knob sets the saturation and
changes between color and color temperature sequence.
With GN at „0“ the color temperature loop is active. Turn the
GN knob clockwise to increase the saturation to 100%.
• Press the JUMP and FUNCT button or the FUNCT button
alone to deactivate the demo mode.
As an alternative activate and deactivate the demo mode in the
menu Setup -> DEMO.
Shift key
This short cut is only available in the main menu. Press the
ENTER button, until a small arrow starts blinking in the display.
Memory 1 or memory 2 calls up one of two factory settings.
DMX control
DMX mode
The L10 offers, depending on the model, up to 15 DMX modes.
Use the 8 bit modes with basic DMX controllers like dimmer
consoles. The most common modes for operation via DMX are
mode 1 and mode 2.
ARRI recommends the use of the 16 bit modes in combination
with DMX controllers supporting 16 bit resolution to obtain best
results. The high resolution provides smooth dimming and pre-
cise color adjustments.
The coarse/fine modes utilize two DMX channels for most pa-
rameters and provide higher resolution compared to the 8 bit
modes in combination with DMX controllers that do not support
16 bit resolution. One channel sets the coarse value of the
function which is divided in 256 increments using the fine chan-
nel.
The setting can be changed any time using the rotary knobs of
the fixture menu.
White and RGBW
This mode provides control of intensity, color temperature, +/-
green and individual channels for controlling the red, green,
blue and white color.