English
- 15 -
2.6 Supply voltage must not exceed the ranges that are given in the "Technical
Data" (see page 21). Check that the power supply voltage and wiring are
suitable for the ballast to be used. Supply voltages which are greater or less
than that specified for the ballast can cause injury to the user as well as
damage to the ballast.
The electronic of the EB is built in a housing with protective class I and
protective rate IP 21.
Ambient operating temperatures must be between -20°C and + 50°C!
Neither back and side heat sinks nor air slots for ventilation should ever be
covered or obstructed.
The EB must be placed only on solid, flat and dry ground. Temperature of the
ground should be less than 50°C. If the EB could sl ip over the ground, it must
be fastened.
Protect EB against direct sunshine. Protection against rain is needed when wind
pushes water drops direct into the air slots of the EB (acc. to protective rate
IP 21).
Do not operate the EB in high humidity (dew) or in aggressive or explosive
gas-air mixtures.
2.7 The Electronic Ballast must be used only according to the directions in this
"Operating Instruction". The manufacturer shall not be liable for any damages
caused by unintended use or wrong operation.
2.8 The user of the Electronic Ballast is urgently requested to observe the
following instructions:
Dispose of packing material properly.
Do not place the ballast into operation if damages are apparent.
To assure safe operation, use EB only according to the information given in
these operating instructions, connect and operate it as shown on the serial
number plate.
In case of malfunction, disconnect the EB from mains (pull out the line plug).
Repairs, exchange of replacement parts and manipulations on the EB must
be carried out by a qualified personnel or ARRI service only.
Use only original spare parts for repairs.
Use only original accessories.
Make worn-out Electronic Ballasts inoperable immediately by pulling out the
line plug and cutting the line cable at the ballast. Then dispose of the
Electronic Ballast properly.
Make sure that children do not operate the EB.
Always switch off the EB and pull out line plug before you clean it or do
maintenance work on it.
Clean EB dry only or with a moist cloth. Never immerse it into water.
Do not use the connection cables of the EB for carrying, do not pull them
over sharp edges, clamp them under doors or clamp them in any other way.
Switch off EB when it is not needed.