![background image](http://html.mh-extra.com/html/arnica/demli/demli_user-manual_2974581009.webp)
DESCRIPTIONS
1. Lid
7. Keeping warm button
2. Handle for tea pot
8. Power base
3. Boiling button
9. Kettle jug
4. Handle for kettle
10. Teapot
5. Switch
11. Filter
6. Boiling mode display
TECHNICAL SPECIFICATIONS
Brand
: Arnica
Model
: Demli
Frequency : 220-240V~ 50-60Hz.
Power
: 1800W
Water Cap. : 1,
8
liters
Teapot Cap. : 1 liter
USAGE
• Before first use, wash your device with water. Boil water 2-3 times in the kettle and change the
water every time. When doing this, make sure that the water is at the maximum level. After each
boil, drain the hot water and wash the inside of your device with cold water.
• After boiling water, it is normal for the formation of specky grades in boiling water compared to
the water hardness level. This is caused by water and there is no harm to human health.
• Always fill the water between min. and max. the levels.
• Do not try to boil the water below the minimum level, do not try to boil the water above the
maximum level.
TEA BREWING
• Open the teapot lid to remove the tea filter from the teapot, and after putting tea in the teapot,
close the teapot lid and place it in place. Put the switch ( 5 ) in the “I” position first and then
put the boiling button ( 3) on the handle .The pilot lamp will turn red and the water will start to
heat up and boil.
• Depending on the amount of water supplied, it will start to boil in a few minutes and it will switch
automatically to the closed position to keep the water boiling at minimum level and reduce the
heating power to save energy. In the meantime, the heating light will go out, the pilot light will
continue to light green.
• Brew the tea with boiling water. If necessary, add water to your kettle jug and move the boil
switch back to the open position.
• When you hold the teapot to fill the tea, peel it off the surface on which it is seated. So the drop
-
lets that have accumulated in the base will be poured into the kettle jug.