1
2
3
36
6
5
INSTALLATION GUIDE
DO NOT
apply heat near this product. Heat generated by soldering
could damage plastic parts and seals.
5.1
Mounting
Before connection, flush water through pipe-work to
remove all debris etc. to prevent damage to the valve
mechanism.
THEN ENSURE WATER SUPPLIES HAVE BEEN
ISOLATED.
Feed the inlet pipe & cables through basin
hole. Allow the spout to rest on the basin
seated on the rubber washer.
2.
Fit the larger rubber washer, brass washer
& back-nut onto the spout tail as shown.
3.
Hand tighten the nut against the brass
washer until the rubber washer makes con-
tact with the underside of the basin. Ensure
the spout is positioned correctly, & then
tighten the back-nut securely with a basin
wrench (36mm A/F).
CABLE COLOURS:
The cables emerging from the spout are connected to
the integral sensor.
BLACK & RED cables will connect to the solenoid valve.
GREY cable will connect onto the PCB inside the PSU
Do not cut these cables
.
1.
Remove the spout mounting kit if already assembled to the spout tail. Ensure the basin rubber washer
(smaller diameter one) is in place as shown. This seal should locate into the base recess of the spout.
Offer the spout towards the basin hole.
