5
3
SUPPLY CONDITIONS
This product is designed to be supplied with water at a pre-mixed temperature or with cold water only.
In order to maintain water quality, the hot supply should be stored & distributed at a temperature greater
than 55°C.
Use of an appropriate temperature reduction device (e.g. tee pattern thermostat) is recommended to
ensure delivery of safe hot water temperatures from the spout.
Avoid supplying scalding water to the spout. Hot water temperature supply should be controlled to circa
40°C.
4
WATER REGULATIONS
The fittings covered by this installation and maintenance instruction should be installed in
accordance with the water regulations published in 1999*, therefore Armitage Shanks would
strongly recommend that these fittings are installed by a professional installer
*A guide to the Water Supply (Water Fittings) Regulations 1999 and the Water Byelaws 2000, Scotland is published by WRAS (Water
Regulations Advisory Scheme) Fern Close, Pen-y-Fan Industrial Estate, Oakdale, Newport, NP11 3EH.
ISBN 0-9539708-0-9
MAX.
5
P
T
°C
bar
MAX. 80
MIN.
0,5
40
Recommended
Abbreviations & terminology used
PSU: P
ower
S
upply
U
nit, either mains, battery or link versions.
PCB: P
rinted
C
ircuit
B
oard inside the PSU.
RCD:
R
esidual
C
urrent
D
evice
SELV: S
afety
E
xtra
L
ow
V
oltage
LINK
PSUs: (up to 5 max) can be connected in series to a single mains PSU. Permit-
ting washroom with multiple products to be run from a single mains supply point.
www.divapor.com
