1
2
3
6
5
INSTALLATION GUIDE
DO NOT
apply heat near this product. Heat generated by soldering
could damage plastic parts and seals.
5.1 Mounting
Before connection, flush water through pipe-work to
remove all debris etc. to prevent damage to the valve
mechanism.
THEN ENSURE WATER SUPPLIES HAVE BEEN
ISOLATED.
Feed the inlet pipe & cables through basin
hole. The cables are protected by the black
corrugated plastic tubing (split). Locate the
spout tail into the basin hole. Allow the spout
to rest on the basin seated on the rubber
washer. Refit the corrugated tube if it slips off
the cables.
2.
Partially fit the two screws into the brass
clamping ring as shown.
From below the basin, fit the larger rubber
washer, brass washer & clamping ring onto
the spout tail as shown.
3.
Hand tighten the clamping ring onto the tail
so that the screws contact the brass washer
which in turn pushes the rubber washer until
it makes contact with the underside of the ba-
sin. Ensure the spout is positioned correctly,
& then tighten the screws securely with a posi
drive screw driver
CABLE COLOURS:
The cables emerging from the spout are connected to
the integral sensor.
BLACK & RED cables will connect to the solenoid valve.
GREY cable will connect onto the PCB inside the PSU
Do not cut these cables
.
1.
Remove the spout mounting kit if already assembled to the spout tail. Ensure the basin rubber washer
(smaller diameter one) is in place as shown. This seal should locate into the base recess of the spout.
Offer the spout towards the basin hole.
