19
ARMASIGHT by FLIR
PVS-14
U S E R M A N U A L
KEEPER
HELMET MOUNT
BRACKET
CATCH
BUCKLE
LEVER
STRAP
REAR
SNAP
REAR
MOUNTING
HOLE
REAR
BRACKET
NAPE
STRAP
FIGURE 3-5. INSTALLATION OF HELMET MOUNT
4. With the catch pushed forward (see Figure 3-5), place the strap over the top of the helmet center
(see Figure 3-6).
5. Hook the rear bracket (see Figure 3-5) on the center of the back of the helmet. Lay the strap, now
hooked to the helmet mount bracket, over the top of the helmet.
6. Hook the helmet mount bracket to the center of the front lip of the helmet and hold it in place (see
Figure 3-6).
TOP EDGE OF MOUNT
MOUNT
RELEASE
KEEPER
HELMET MOUNT
BRACKET
STRAP
MOUNT IS ROTATED
90° FOR CLARITY
FIGURE 3-6. HELMET MOUNT
7. With the buckle lever open, use the catch to remove the slack in the strap. Close the buckle lever.
8. Disengage the neck strap latch on the left side of neck strap.
9. Put the helmet on. Do not fasten the helmet chinstrap.
10. Hold the neck strap where the strap meets the latch. Tighten the strap until it fits securely, then
install and tighten the helmet chinstrap. The brow of the helmet should be parallel to the ground,
and the helmet should be stable on the head.