www.
Armagard
.com
Page |
6
Toll Free (US):
1-866-434-0807
Call (UK):
0121-608-7210
Step 13: Once your settings have been completed, turn off the enclosures power and
remove the 20-pin connector. Then secure the Plastic cover back onto the PCB and turn the
power back on.
For the board to control the media/equipment housed in the enclosure they must be
connected to the controller board. The controller board can supply power by wiring cables
into one of the three power outlets. To do this follow the steps below:
Warning: Make sure the enclosures power is switched off and unplugged before removing
the Plastic cover to avoid the risk of an electric shock.
Figure 1a
Step 1: Use a crosshead screwdriver to remove the Plastic cover that covers the PCB board
and place to one side (figure 1a).
Step 2: Secure the relevant wires specific to your region into the ‘Neutral (N), Live (L) and
Earthed (E)’ outlets (figure 2a).
Figure 2a
Media/TV Outlets x3
