For all Sales and Service enquiries
Phone (03) 9727 8860 Fax 1300 360 650
© This instruction leaflet is subject to copyright and must not be reproduced,
copied or otherwise used in any way or for any purpose without the consent
in writing of the owner.
Arlec Guarantee
Arlec guarantees this product against defects
in materials and/or workmanship, under
normal domestic use and conditions for 24
months from the date of purchase.
Except as otherwise provided for by
Trade Practices Act and State Consumer
Legislation, this guarantee becomes void if, in
the opinion of Arlec:
•
The product has been misused, abused
•
Used in commercial application
•
Installed incorrectly
•
Modified or installed by an unauthorised
person
•
Has been damaged in transit subsequent
to purchase
•
Connected to electrical supply not
corresponding to the product’s
specification
•
The product has been used with type of
controller not recommended by Arlec.
If any part of the product proves defective
within the warranty period, such part will be
repaired or replaced free of charge at the
discretion of Arlec.
The purchaser of the fan is to be responsible for:
•
Travel costs incurred where service is
requested at premises or at such time
outside normal areas or times as defined by
Arlec or their authorised agent.
•
Transport and insurance costs if product or
parts have to be returned for repair or
replacement to Arlec or their authorised
agent.
•
Repair of defect not covered by this
warranty
To claim under this guarantee, the purchaser
must produce proof of purchase, plus proof of
installation (contractor invoice and contractor
licence number) and
Installation record form
must be completed.
Guarantee does not include installation, minor running noise,
loosening of components assembled by installer, bulbs and glass
used in light fittings, minor wobble of fan.
TROUBLE SHOOTING CHECKLIST
TROUBLE
Fan will not start
Fan wobbles
Fan sounds noisy
Mechanical Noise
PROBLEM CAUSE
a. Fuse or circuit breaker blown
b. Loose power line connections to the fan.
c. Reversing switch (where applicable)
neither up or down.
d. Speed controller not in correct position.
a. Fan blades not horizontal to ceiling
b. Blade screws are loose
a. Light kit glassware loose or rattling
b. Incorrect bulb(s) being used in light kit.
c. Loose fan blade screws
d. Ceiling fan not secured against ceiling
e. Incorrect speed controller
SUGGESTED REMEDY
a. Check main and branch circuit fuses or circuit
breakers.
b. Check line wire connections to fan.
c. Push switch either fully up or down.
d. Check speed controller’s position.
a. Measure from ceiling to tip of blades, then rotate
fan so all 4 blades are checked for equal height
from ceiling. (Note: adjustments may be made by
slight pressure up or down on blade holders).
Make sure all screws are securely fastened.
a. Brass knob securing glass should be finger tight.
b. Check suggested bulb(s) in light kit
c. Re-tighten all screws on fan blades but never
over-tighten
d. Re-tighten all screws in the hanging bracket
or plate.
e. Change the controller to the one supplied.
Re-tighten the screws in the upper side of the fan
motor body.
a. Allow for at least 8 hours settling-in period.
6
CSFseries Instructs 28/7/05 4:56 PM Page 6