Fig 3. Wiring Diagram
1. Choose a location for the fan which will
ensure adequate clearance from all objects
and walls and greater than 2.1 metres from
the floor.
2. At the selected mounting position, check
whether there is a ceiling joist to which the
fan can be secured. If there is no suitable
supporting member, install a 50 x 100mm
brace between ceiling joists.
Secure the mounting plate (1) to the ceiling
with two mounting screws (5) (with rubber
levelling pads beneath if required).
Note: Install the mounting plate with the
installation hook towards the floor.
Temporarily hang the top canopy by the
installation hook through a mounting hole.
This hook will support the entire weight of the
motor housing while wiring installation takes
place.
3. It is necessary to run wiring between the fan
location to the location of the wall controller.
Light
Switch
Wall Controller
Supply
Active
Supply
Neutral
Supply
Earth
Leads to Light
(White Active, Blue Neutral)
Note: Ensure
both internal
earth wires are
connected to
supply Earth
5. Fit the fan blades.
For metal blades:
Fit the blade with the bracket facing up.
Ensure that the fibre washer is fitted between
the bracket and motor housing as shown in Fig 5.
For wooden/rattan blades:
First assemble the blades.
Assemble using screws, washers and nuts in
the order as shown in Fig 6. Use 3 sets of
screws washers and nuts for each bracket and
blade. Tighten the screws firmly without over
tightening.
Once assembled, fit the blades to the fan motor
in the same way as for the metal blade shown
in Fig 5, but with the bracket facing
down
.
3
Fig 2.
Fig 4.
Wiring should be at least 1mm
2
cross section,
the fan must be earthed.
Wiring for light adaption shown dotted -
omit if adaption is not to be used.
4. (a) Thread two canopy fixing screws and lock
washers (3) into two opposite holes in the
rim of the mounting plate. (fig.4)
(b) Thread the screws into the holes until
approximately 5mm remains between the
screw head and the rim of mounting plate.
(c) Remove the canopy from the installation
hook on the mounting plate.
(d) Slide the canopy (8) up the downrod onto
the mounting bracket and align the locking
slots of the canopy with the two screws
installed in step (a).
(e) Push up to engage the slots and turn
clockwise to lock into place. Immediately
tighten the two mounting screws.
(f) Install the remaining two mounting screws
into holes in the canopy and tighten firmly.
Locking Slot
5mm
Top
Canopy
Fixing
Screw
and Lock
Washer
Connect wires to light terminals
Levelling pad
Mounting
Plate
Washer
Mounting
Screw
Installation
Hook
CSFseries Instructs 28/7/05 4:56 PM Page 3