6
7
Chiller Bottles
The chiller bottles provided with the
unit must be filled with water and must
be allowed to freeze in a refrigerating
unit (in an upright position) prior to
their use in the cooler unit.
The strings provided in the side water
entrance of the unit is secured to the
chiller bottle cap hook (as shown in
Fig 1.) before placing the bottle into the
cooler unit. Fig 2.
Cleaning and Maintenance
• Always switch off and unplug
from the mains supply before
attempting any kind of cleaning and
maintenance.
• After extended period of use, replace
the water in the tank with fresh
water.
• The air filter (only) at the inlet at the
rear of the unit can be cleaned if
required. The foam filter should be
cleaned in a mild soapy solution,
then left to dry before replacing.
• External enclosure can be cleaned
with a damp cloth.
Cleaning the Air Filter
Unplug the power cord, loosen the
screw of the air filter to remove the air
filter. In a smoky or dusty environment
the filter may appear gray after 1-2
months and will need to be cleaned. In
conditions without smoke or minimal
dust, the filter to be cleaned every 1-6
months depending on the condition of
the filter.
Wash the air filter with warm soapy
water and a soft brush. Place side of
filter with the light contact agent facing
upwards in the sun for at least 4 hours
to re-generate the light contact agent
and re-fit it back in the unit.
Fig 1.
Fig 2.
AEC001 Instructions.indd 6
31/7/09 3:57:40 PM