Arktic 274231, User Manual, Page: 6 / 68

6
EN
7. Digital display: it will show the following mes-
sages during operation:
7a.- Motor running for the rotation of stirrer
7b.- Cooling operation
7c.- Temperature at the bottom of the removable
container (Range: -10°C ~ -35°C)
7d.- Timer (Default: 90 minutes). Remaining time
during ice-cream making operation
8. STANDBY/OFF button: Press to switch to STAND-
BY or OFF mode of the appliance
9. START/PAUSE button: Press to start ice cream
making operation. Press again to pause.
10. Time setting buttons
: decrease the time of operation
: increase the time of operation
Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged
and with all accessories (e.g. plastic scoop, stir-
rer, ice-cream container, measuring cup). In case
of incomplete delivery and damages. Please con-
tact supplier (See ==> Warranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 10 cm around the appli-
ance.
Operation
Warning:
Make sure the appliance is unplugged from the electrical power supply.
Preparation for the ingredients of making ice-cream
• First, prepare all the ingredients for making the
ice-cream according to recommended recipe.
• Then, place the removable container inside the
appliance.
• Next, place the stirrer in the center of the remov-
able container.
• After that, fill the ice-cream container (2) with
the prepared ingredients. The ingredients should
be well cooled before (about 10°C). Never being
warm or hot.
Note: To avoid spilling of the excessive cream
from the ice-cream container during operation,
fill the ice-cream container with up to 60% of its
total capacity. Ice-cream will expand during op-
eration and fill the whole container.
• Now, mount and lock the transparent lid (1) by
turning it anti-clockwise. Observe the marking
on the outside of the lid (1).
• Connect the plug to a suitable, single electrical
power supply. A short beep sound will be heard.
• Switch to STANDBY mode by pressing STANDY-
BY/OFF button (8).