Agrimag User Guide
5
V1.9 26-4-2019
The sensor head has to be properly
tightened
During the sensor installation please check the
head and the four screws for proper tight.
Removal during maintenance
If the application requires removal of the sensor
for periodic maintenance, it is recommended to
install a bypass section as the drawing below.
2.2. Position of flowmeter
This is an all position flowmeter which can be installed either vertically or horizontally, register up, down or
angled. However, entrained air or solids may make some positions preferable to others. See the position
diagram for guidance. The correct position will be related to the function of the electrodes. The two
electrodes located on the vertical axis of the flowmeter are used for earthing purposes. The two electrodes
located on the horizontal axis of the flowmeters are used for measuring.
In this position, if there are any air bubbles or
if sediments accumulate in the lower part
of the flowmeter, it will could have an adverse
effect on the earthing, which could influence the
accuracy of the measurement.
By rotating the flowmeter, it is possible to prevent
the sediments accumulating at the earthing
electrodes. Also there is less chance of the air
bubbles affecting the earthing electrode.
Summary of Contents for Agrimag Series
Page 1: ......
