chips with foam glue. Then cut off the excess parts.
Pick out the carbon rods and carbon chips in the picture. The carbon chips are used to strengthen
airfoil and carbon rods are used to strengthen plane control surface. Stick the carbon rods with
glue 502 and stick the carbon chips with foam glue.
Meanwhile, install the ESC as shown above left picture. Locate 4 carbon rods of 5mm, 2 carbon
rods are long and 2 carbon rods are short. Then assemble the ESC with motor base to the airfoil.
The short carbon rods will go through the motor base as shown in the picture. But only the
carbon rods are to be glued. The motor base should not be glued, it is the final step to fix motor
base. The side assembled with ESC is belly of plane. The side assembled with servo is back of
plane.
Preparing rudders: pick out rudder parts and stick them with glue 502 as shown in the pictures.
Remind keeping the front edge in alignment.
