-6-
4)
Bi-motor mixed control, when throttle is less than 25%, there is no differential steering, when over
25%, throttle outputs differential steering.
5)
You can plug the airspeed sensor into paralleling "RX" port if using GCS function.
Attention:
1.
If the camera needs a 5V supply, please connect a BEC from 12V or main power
.
Do not connect CPU 5V for
a 5V camera in case of the power supply shortage
.
2.
Connect Receiver's CH1-7 to IN PORT or use a PPM connection.PPM interface supports Arkbird 433 receiver
to achieve single-wire 10 Channel transmission and signal strength RSSI (automatically identified when
plugged in).
3.
The digital high-accuracy airspeed meter of Arkbird 2.0, can calculate the relative speed between the plane
and air, which is different from GPS ground speed.
As the air speed is a necessary condition for generation
of lift force. Insufficient airspeed may cause stall. The airspeed meter collects the speed in front of the plane.
As to flying in windy days or when flight is heavy-loaded, it will increase throttle when flying upwind and
decrease when flying downwind.
4.
Extension wire can be used. Do not make the orifice get close to the motor so as to avoid airflow
interference. After power on, it will be calibrated automatically within 10 seconds. During this period, do
not touch the orifice.
5.
When the airspeed meter is connected, the OSD will display the airspeed A 0km/h. Under the RTH and
waypoint mode, either air speed or ground speed is lower than the set “safe speed”, Autopilot will
increase the throttle proportionally.
Attention: The airspeed meter only participates in control under the mode of returning or waypoint etc. Under
the balance or manual mode, it does not participate in control. In this time keep an eye on the value on the
airspeed meter for reference.
