7
3)
Power on. Beware the plug is xt30 and there is a difference between position and negative pole;
4)
After powering on the motor then check its condition:
The motor will continuously beep;
Power LED of transmitter (blue) will be constant on;
LED of GPS (blue) will be constant on;
The LED (yellow) of 433 receiver in the cabin will slowly or fast flash;
If the monitor and 5.8G receiver has been matched already, at first, the frequency of the transmitter and the receiver should
be the same. And then, connecting the monitor and receiver.
Upon they are connected, the OSD will display following parameters:
If GPS has been installed, the motor will slowly beep every 1 second.
Or if the GPS has not been installed, the OSD will display parameters as follows:
*Please ensure that all data about monitor, autopilot, transmitter and 433 receiver is reasonably correct. Then power
off the airplane.
Step 4: Prepare PWM of 433 UHF
1.
The wire connection of 433 transmitter (sold separately) and radio receiver
The 433 transmitter is a separated part of the 433 system, and should be purchased. Please make sure that CH5 and
CH6 can be controlled by at least two or more switches on your radio. Please see the following picture:
