Arkbird
- 4 -
The OSD interface automatically displays the RSSI strength A99.
Flight / Mix / Gimbal can be selected on the OSD menu, by which channel 9 and 10 output can be
set to steer a Servo
-
Stabilizing-Gimbal for camera (radio TX channel 7&8 can control direction & pitch).
Positive & negative compensation and the controlling amount can be adjusted.
5. Frequently Asked Questions (FAQ)
Q: Unable to control the servo?
A: Check the wiring, match the r
eceiver’s ID code, transmitter and receiver LED will flash fast and
smoothly. Check if the radio TX is set to PPM mode, (or 2.4G/72M receiver is working and able to control
a servo).
If you use the Arkbird OSD single wire transmission, enter the OSD menu; check the first row, to
see whether it is upgraded to latest firmware (above V3.1020).
Q: Short distance, Failsafe less than 5km under maximum power (LED brightest)
A: check RSSI intensity through OSD, if signal is still not A00, it may be failsafe from repeater
receiver.
Check if the UHF TX antenna, RX antenna is installed firmly and perpendicular to the horizontal
plane.
Strongly recommend using the original antenna, which is selected specifically for the frequency
hopping system (wide band and appropriate), other high gain antenna for fixed frequency system may be
not suitable for Arkbird frequency hopping algorithm.