001.23104.EN rev
. 6
Preparation / Transport
7
Initial Setting
The
MAXI LITE
floor lift does not require any
initial setting except for the battery pack which
must be charged for at least 8 hours prior first
usage.
Transporting the Lift
WARNING
: To prevent back injuries, never
attempt to lift, transport, fold or unfold the lift
without being assisted.
The
MAXI LITE
floor lift can be folded to fit
inside the trunk of most domestic vehicle for
transport.
See “Unfolding the Lift” and “Folding the Lift”
sections for details.
Unfolding the Lift
1) Lock both rear casters.
Fig. 3
2) Remove the mast locking screw.
Fig. 4
3) Unfold the lift until it is straightened out.
NOTE:
Make sure the mast pivot remains on
top of the groove when unfolding the mast.
Otherwise the pivot might slide down the
groove and block, see “Fig. 5”.
Fig. 5
4) Insert the locking screw back to block the
mast, and then tighten the knobs.
Fig. 6
Folding the Lift
1) Lock both rear castors of the lift.
2) Remove the DPS (if equipped), see
“Attaching / Detaching the DPS Spreader
Bar” on page 12.
3) Lower the boom to its lowest position.
4) Remove the battery pack.
5) Remove the shoulder knob and the turning
knob from the mast.
Fig. 7
6) Pull the mast up and lean it forward to bring
the pivot bolt in the upper section of the
groove.
7) Fold the lift until the boom touches the floor.
8) Insert the shoulder knob back in the proper
place to lock the mast.
Fig. 8
Preparation / Transport
