Arjohuntleigh 700-31400, Installation Manual

Page: 11 / 28

001-31430-EN r
ev.1 • 05/2017
7 Install Receiving Modules
How To Install the Receiving Module
4) Insert the receiving module into the Kwiktrak
system: (Fig. 4)
a. For the curtain gap:
Make sure you insert
the receiving module
with its door facing the
docking station and
charging station.
REMINDER:
If an ECS receiving module is being installed,
special care must be taken during the procedure
to ensure the ECS
Maxi Sky
2 Transportable will
be able to charge properly after it is installed into
the ECS receiving module.
When inserting the receiving module into the
Kwiktrak, make sure the contact box of the ECS
receiving module is in contact with the ECS
contact strips located inside the Kwiktrak.
(Fig. 5)
5) Place the end stopper back into the track, at
50mm (2") from the end of the track and
screw it in place using the 6 mm allen key
and torque to 20 Nm (15 lb ft): (Fig. 6)
a. If an ECS contact
box was previously
removed, put it back
inside the tracks,
as close as
possible to the
end stopper.
6) Place the plastic cap back onto the end of
the Kwiktrak: (Fig. 7)
a. To place the plastic
cap back onto the end
of the ECS Kwiktrak
system, you will need
to use the
6 mm Allen key to
tighten the screw
securing the plastic
cap inside the Kwiktrak.
Curtain Gap
WARNING: To avoid bodily injuries, make sure the end stoppers are correctly installed and
tightened at all tracks ends.
C-Stat
CAUTION: To prevent possible damage to
product, do not open door under clip on
accessories such as charging/detection station.
Fig. 4
Fig. 5
C-Stat
Fig. 7
ECS
Fig. 6
ECS