Arizona Model
Air
crafters
VICKERS
Assembly Drawings
All Scales
Page 3
Step 6.
Attach the cooling barrel to the lock assembly
.
Use the gun barrel tube to help in the mounting after cutting the tube to the proper length. Refer to the scale reference for the proper length.
Next attach the parts to the lock assembly as shown in the diagram below
.
Step 7.
Assemble the cocking lever as shown. Clip a brass pin to help in securing the ball to the lever
.
When dry attach to the lock
assembly in the order shown below
.
Step 8.
Mount the lever assembly in position using
a brass pin to help in securing to the lock assembly
.
Step 9. (optional)
The ammo feed chute is constructed using parts Q and R.
Cover sides J with sheeting parts R after filing to shape.
Mount to the ammo feed port.
The flash supressor can be made using parts Z. Mount both parts
on the barrel, one at the end of the barrel the other flush to end cap
W
.
W
rap between both parts with heavy tape in the same manner as
the cooling barrel.
Clip heads from pins and install
on both sides simulating rivet heads.
P
N
Optional Brass
W
asher
Mount underneath
for movable lever
.
(not included in kit)
J
K
L
V
Ball
O
M
Use a small dowel or aluminum tubing (not included)
for standof
f posts. Locations designated with Gray
Mount Last
D
E
R
Q
Q
Q
Side
V
iew
Remove after assembly
to expose ammunition.
Supply side only
.
V
Laminate parts together
(two or three depending on scale)
Z
Laminate parts together
(Number varies depending on scale)
Center in part
Sides covers
Inside laminates
Laminate end pieces
Flash suppresser
Optional Sight position
T
op
T
op
Side
Side
Side
Side
