ARITERM GSM A2
ARITERM SWEDEN AB
Installation instructions -
2011.11.24 - Page 2/8
Introduction
Ariterm GSM-A2 is a compact universal alarm transmitter that transmits alarms
and receives commands via SMS. The alarm and status changes appear as
explanatory text depending on which pre-programming one selects.
The alarm goes to the telephone number that initiates A2.
One can then add more numbers via SMS.
GSM-A2 is designed for GSM technology and requires a valid SIM card.
Works with operators in the 2G network and higher.
Both pay-as-you-go and subscriptions can be used.
Connection / Quick start
1. Connect the burner or stove according to the diagrams on the following
pages. If one connects a burner or stove with control CC05 it must
be connected according to image A and B. The Remote function must
be activated in the controller Service menu (See manual).
2. Carefully slide the SIM card into the A2’s upper edge with the chip
towards you and the bevel down to the left. Image C.
3. Connect 9208 AC -DC adapter 24Vdc to a wall socket. When the voltage
supply is connected the “Status” flashes quickly for 30-40 seconds, then
1-5 slow flashes. The flashes displays the GSM network signal strength.
4. Initiate the unit by SMSing
Ariterm!!
or
Ariterm!!01
depending on the
connection used. Note that the number used for initiation is the first
number receiving alarms. Check the unit by SMSing
Status?
5. Add more numbers that receive alarms by SMSing
TELE!*2
followed by
the mobile number that will receive alarms.
Country prefix (eg +46 for Sweden) replaces the first zero in the
telephone number.
Such as
TELE!*2 +4670123456
TELE!*3 +4671234567
and so on.
Image A
