ARITCO 7000 Series, Technical Documentation Manual

Page: 61 / 85

26 7000 300 en 00
38
‡
Control panel lighting and emer-
gency light Test the function of the normal lighting above the
destination buttons on control panel (7 leds) by
pressing a destination button. The emergency
lighting (5 leds) on the platform panel shall light
up automatically when the mains isolator is
switched off.
39
‡
Hand rail Visually inspect the handrail.
40
‡
Gap platform - shaft/doors The gap between the platform edge and the shaft
shall not exceed 15 mm, and the parts shall not
be in contact. This applies to the total height of
the travel.
41
‡
Sufficient space Free height from the platform floor to the top
floor level ceiling shall be at least 2000 mm.
Free area in front of the electrical cabinet of 0.7
m.
42
‡
Fitting of platform Check that the platform is fixed with all 8 screws
and tight to the frame.
43
‡
Floor levelling max. 10 mm devia-
tion
44
‡
Label for “hazard of falling” Visual inspect that there is a “hazard of falling”
label on the safety edge on the side where there
is a door opening.
45
‡
Platform cleaned out
MOTOR/SCREW/GUIDES
46
‡
Oil for lubrication of screw 1. For manual lubrication - Check that there is oil
up to the mark on the oil container. The roller and
the roller is functioning. When the lift is its lowest
level, check that the roller dips down in the bot-
tom of the container. The roller shall rotate
against the screw when travelling up.
2. For automatic lubrication - Visually inspect
that oil is lubricating the screw end in the top
according to the settings on the control board on
the platform. The purpose of the container is to
collect used oil. The roller should be fixated 50
mm over the bottom of the container. The roller
shall rotate against the screw when travelling up.
47
‡
Self-sustaining Self-sustaining is checked by driving the lift
down from the electrical cabinet with the button
"Friction Test" pushed in during the test. The lift
shall stop within 1 m.