Ariston VENCON ECO 100, Manual

Page: 19 / 152

19
GB
This product conforms to Directive WEEE 2012/19/EU.
The barred dustbin symbol appearing on the appliance indicates that the product must be disposed of separately from household
waste once it reaches the end of its lifespan, and transferred to a waste disposal site for electric and electronic equipment, or returned
to the dealer when purchasing a new device of the same kind.
The user is responsible for delivering the decommissioned device to a suitable waste disposal site. Proper separated collection of the
decommissioned device and its subsequent eco-compatible recycling, treatment and disposal helps to prevent negative effects on the
environment and health, besides encouraging the reuse of the materials comprising the product.
For further details on the available waste collection systems, contact your local waste disposal office, or the dealer from
which the product was purchased.
Insufficient hot water supply
Water leaking from the pressure safety device
AT ALL EVENTS, DO NOT TRY TO REPAIR THE APPLIANCE: ALWAYS CONTACT
QUALIFIED TECHNICAL PERSONNEL.
The above-mentioned data and features are not binding for the manufacturer, who reserves the
right to effect any changes deemed necessary without prior notice any without being obliged to
replace the product.
Water comes out boiling hot (steam out of the taps)
USEFUL INFORMATION
If the water comes out cold
This product conforms to Directives RoHS 2 2011/65/EU - REACH 1907/2006/EC.
It is normal for some water to trickle from the device during the heating phase. To prevent water from trickling, an
expansion vessel must be installed on the flow system.
If the dripping continues even after the heating phase, have the following checked:
- the device calibration;
- the pressure of the water mains.
Warning: be careful never to obstruct the device’s discharge outlet!
Make sure to check:
- whether the terminal board is powered;
- the PCB;
- the heating components of the heating element.
Disconnect the appliance from the power supply and check the following:
- the PCB;
- the level of limescale build-up in the tank and on the components.
Make sure to check:
- the pressure of the mains water;
- the condition of the deflector (jet breaker) on the cold water inlet pipe;
- the condition of the hot water inlet pipe;
- the electrical components.