Ariston TOP WIFI, Manual

Page: 62 / 136

Hybrid electric water heater (WiFi model) – OPERATING AND MAINTENANCE INSTRUCTIONS FOR THE USER
61
If the connection fails, carefully check and repeat the above steps.
Note: The password cannot be Chinese characters. If there is any Chinese characters, please modify it.
•
APP Layout
Following functions are included (Fig. 14):
-
On/Off (A, Fig. 14);
-
Monadlity i-MEMORY, GREEN, PROGRAMMING and BOOST (B, Fig. 14);
-
Knob for adjusting of temperature. Press and slide for increase or decrease the desidered temperature or
use the b and –. The set temperature is shown in red (eg. 45°) and the une detected indside the
tank in gray (eg. 32°) (C, Fig. 14);
-
Number of available shower. (D, Fig. 14);
-
Button for set-up page (E, Fig.14)
Sliding on the right other pages are available.
•
Connection Status Description
Button Wi-Fi
On The Wi-Fi module has been connected to the home
network.
Slow flash The Wi-Fi module is connecting with the home
network.
Fast flash The Wi-Fi module is already on.
Off The Wi-Fi module function is off.
Visualization icon
Text AP The Wi-Fi module is already on and can be connected
to the home network.
icon Wi-Fi
Successful APP connection, APP operation can begin.
8 MAINTENANCE REGULATIONS (for authorised personnel)
WARNING! Carefully follow the general warnings and safety rules listed in the preceding sections, in
strict adherence to the provisions contained therein.
All maintenance operations and interventions must be performed by qualified personnel (have the necessary
qualifications as required by applicable legislation).
Following scheduled or unscheduled maintenance, it is advisable to flush out the tank to remove any remaining
impurities.
8.1 Draining the appliance
The appliance must be drained if left inactive in a room subject to frost and/or in the event of prolonged inactivity.
When necessary, empty the appliance as follows:
-
Disconnect the appliance from the mains.
-
Close the shut-off valve, if installed, or the central tap of the domestic water supply network.
-
Open the hot water tap (washbasin or bathtub).
-
open the cock on the safety device (in countries which acknowledge EN 1487) or the special cock installed on
the "T" fitting, as described in paragraph 4.3.
8.2 Regular maintenance
It is recommended that the evaporator be cleaned on an annual basis in order to remove any dust or obstructions.
To access the evaporator, it is necessary to remove the screws from the front casing.
Clean the evaporator using a flexible brush, being careful not to cause damage. If a fin has been bent, straighten it
using a fin comb (1.6 mm spacer).
Ensure the grille is perfectly clean.
Check that the condensate drainage pipe is not obstructed.
Only use original spare parts.