13
GB
!
Before placing your new appliance into operation
please read these operating instructions carefully.
They contain important information for safe use, for
installation and for care of the appliance.
!
Please keep these operating instructions for future
reference. Pass them on to possible new owners of
the appliance.
Positioning
!
Keep packaging material out of the reach of
children.
It can become a choking or suffocation
hazard. (
see Precautions and tips
).
!
The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to persons,
animals or may damage property.
Fitting the appliance
Use the appropriate cabinet to ensure that the
appliance functions properly.
The panels adjacent to the oven must be made of
heat-resistant material.
Cabinets with a veneer exterior must be assembled
with glues which can withstand temperatures of up
to 100°C.
to install the oven under the counter (
see diagram
)
and in a kitchen unit, the cabinet must have the
following dimensions:
!
The appliance must not come into contact with
electrical parts once it has been installed.
The consumption indications on the data plate have
been calculated for this type of installation.
Ventilation
To ensure good ventilation, the back panel of the
cabinet must be removed. It is advisable to install the
oven so that it rests on two strips of wood, or on a
completely flat surface with an opening of at least 45 x
560 mm (
see diagrams
).
Centring and fastening
1. Place brackets
A
up against the oven support
B
.
2. Place the tabs
C
up against brackets
A
. In
particular, if the cabinet side panel:
is 16 mm thick: mount the tab so that the
number 16 it features is facing you;
is 18 mm thick: mount the tab so that the part
without any wording is facing you;
is 20 mm thick: do not mount the tab.
3. Fasten the brackets and tabs on the oven cabinet
side panel using screws
D
.
4. Fasten the oven to the cabinet using the screws
and plastic washers
E
.
Electrical connections
!
Ovens equipped with a three-pole power supply
cable are designed to operate with alternating current
at the voltage and frequency indicated on the data
plate located on the appliance (
see below
).
Installation
595 mm.
595 mm.
24 mm.
545 mm.
5 mm.
567 mm.
23 mm.
593 mm.
45 mm.
558 mm.
560 mm.
45 mm.
D
A
B
D
D
16
16
16
16
C
C
C
E
E
Summary of Contents for FC 52 C.2
