Ariston 3319122, Assembly And Operation Instructions Manual

Page: 12 / 76

250ms
Zone 1&2
Zone 3&4
Zone 5&6
2s
12 - GB
• Check that the connection between
the receiver and the heat genera-
tor has been completed successfully
(green led on) (Fig. 8) as instructed in
the receiver's instruction booklet.
• Check that the wireless 2 zone kit is
powered up (green led on) (Fig. 8)
• Hold the button on the wireless 2 zone
kit down for 3 seconds; the red led will
start flashing.
• Press the wireless 2 zone kit button
down again to associate the zones to
the outputs.
The red led will flash to indicate the as-
sociated zones:
1 flash every 2 seconds: zones 1 & 2
2 flashes every 2 seconds: zones 3 & 4
3 flashes every 2 seconds: zones 5 & 6
associating the wireless device
RED LED GREEN LED
BUTTON
Fig. 8
• Once the zones have been selected,
hold the receiver key down for 5 sec-
onds; the red led will flash quickly 3
times and then go off.
The association procedure now starts.
• If the procedure has terminated suc-
cessfully, the red led on the wireless 2
zone kit will go out.
LED STATUS DIAGNOSTICS
GREEN
OFF Controller not powered up or system reset
ON Controller powered up
RED
OFF Device associated
n -- flashes every 2 seconds Zone selection
Rapid flashing Cancel radio association
ON Device not associated
DIAGNOSTICS