| 3 - W-118 Overview | 10
Ethernet (LAN2)
Gigabit Ethernet port that
can be used for wired
extension for an SSID.
RJ45
10/100/1000 Mbps Gigabit
Ethernet
Ethernet (LAN1)
Gigabit Ethernet port that
can be used for wired
extension for an SSID.
RJ45
10/100/1000 Mbps Gigabit
Ethernet
Reset
Resets the W-118 device
to factory defaults. To
reset the device, press and
hold the Reset Pin Hole
until all LEDs go off which
indicates that the device
has rebooted. Pressing the
Reset Pin Hole while the
device is booting up will not
have any effect. You should
perform this operation only
when the device is running.
Pin hole push button
Hold down and power cycle
the device to reset
When you reset the device, the following settings are reset:
•
Config shell password is reset to config.
•
Server discovery value is erased and changed to the default, wifi-security-server.
•
All the VLAN configurations are lost.
•
If static IP is configured on the device, the IP address is erased and DHCP mode is set. The
factory default IP address of the device is 169.254.11.74.
