Install the Access Point
This chapter contains the stepwise procedure to install the access point (AP).
Zero-Configuration of the Access Point
Zero-configuration is supported under the following conditions:
• The device is in AP mode with background scanning on and no SSID configured.
• A DNS entry wifi-security-server is set up on all the DNS servers. This entry should point to the IP address
of the server. By default, the AP looks for the DNS entry wifi-security-server.
• The AP is on a subnet that is DHCP enabled.
Important: If the AP is on a network segment that is separated from the server by a firewall, you must
first open port 3851 for bidirectional User Datagram Protocol (UDP) and Transport Control Protocol
(TCP) traffic on that firewall. This port number is assigned to Arista Networks. Zero-configuration cannot
work if multiple APs are set up to connect to multiple servers. In this case, the APs must be configured
manually. For details on how to configure an AP manually, see the Access Point Configuration Guide on
our website at
https://www.arista.com/en/support/product-documentation
Take a configured AP; that is, ensure that a static IP is assigned to the AP or the settings have been changed for
DHCP. Note the MAC address and the IP address of the AP in a safe place before it is installed in a hard-to-reach
location. The MAC address of the AP is printed on a label at the bottom of the product.
The steps to install the AP with no configuration (zero-configuration) are as follows:
1.
Ceiling Mount the Access Point
on page 10 or
on page 11.
2.
Connect the Access Point to the Network
on page 14.
3.
on page 14.
Ceiling Mount the Access Point
Mounting the access point (AP) on the ceiling consists of the following steps:
1. Affix the bracket to the T -grid: Use the mounting bracket to install the AP on the ceiling. Fix the bracket
to the T-grid and rotate the bracket so that it snaps on the T-grid. The bracket is now parallel to an arm of
the T-grid. Ensure that the bracket is properly snapped to the T-grid, as shown below.
Quick Start Guide: Access Point
10
