Chapter 4
Cabling the Switch
The following topics are covered in this section:
•
•
•
Connecting Serial and Management Cables
4.1
Grounding the Switch
After mounting the switch into the rack, connect the switch to the data center ground.
Earth Grounding Pad Sockets for Models without Management Ports on the Rear Panel
location of the grounding pads located on the bottom corners of the rear panel for the models that have
no management ports on the rear panel.
Figure 15: Earth Grounding Pad Sockets for Models with
Management Ports on the Rear Panel
displays the location of the grounding pads on the rear panel for
models that have management ports on the rear panel. There are threaded holes under the sticker on
the right (next to PS2) that warns about “1 min”.
Figure 16: DCS-7060PX4-32 and DCS-7060DX4-32
displays the rear panel of the DCS-7060PX4-32 and DCS-7060DX4-32 devices.
Important: Grounding wires and grounding lugs (M4 x 0.7) are not supplied. Wire size should
meet local and national installation requirements. Commercially available 6 AWG wire is
recommended for installations in the U.S
.
À la terre et de mise à la terre fils cosses (M4 x 0.7) ne sont pas fournis. Calibre des fils doit
satisfaire des exigences de l’installation locale et nationale. Disponible dans le commerce 6 fils
AWG est recommandé pour les installations aux États-Unis.
Figure 14: Earth Grounding Pad Sockets for Models without Management Ports on the Rear
Panel
1 Earth grounding pad
Figure 15: Earth Grounding Pad Sockets for Models with Management Ports on the Rear Panel
1 Earth grounding pad
17
