Chapter 2 –
Important Saftey Instructions
The following safety instructions and warnings apply to the installation and operation of this product.
Statement 1001 –
Read the installation instructions before connecting the system to the power source.
Statement 1002 –
To prevent the switch from overheating, do not operate it in an area with the ambient
temperature higher than 104ºF (40ºC).
Statement 1005 –
Installation of this equipment must comply with local and national electrical codes.
If necessary, consult with the appropriate regulatory agencies and inspection authori
ties to ensure compliance.
Statement 1007 –
Do not physically stack units on any other equipment.
Statement 1009 –
Never lift the chassis using handles on modules.
Statement 1010 –
This equipment must be grounded. Never defeat the ground conductor.
Statement 1012 –
When installing this equipment, connect the ground conductor fi rst.
Statement 1015 –
This unit may have more than one power supply connection. All power connections
must be removed to de-energize the unit.
Statement 1020 –
The power input plug-socket combination must be accessible at all times because it
serves as the main disconnecting device.
Statement 1025 –
This unit requires overcurrent protection.
Statement 1030 –
Only qualifi ed personnel should install, service or replace this equipment.
Statement 1035 –
No user serviceable parts inside. Refer all servicing to qualifi ed service personnel.
Statement 1040 –
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Statement 1050 –
Class 1 Laser Product: This product has provisions to install Class 1 laser transceivers
that provides optical coupling to the communication network. Once a Class 1 laser
product is installed, the equipment is a Class 1 Laser Product (Appareil à Laser de Classe
1). The customer is responsible for selecting and installing the Class 1 laser transceiver
and for insuring that the Class 1 AEL (Allowable Emission Limit) per EN/IEC 60825, CSA
E60825-1, and Code of Federal Regulations 21 CFR 1040 is not exceeded after the la-
ser transceiver have been installed. Do not install laser products whose class rating is
greater than 1. Refer to all safety instructions that accompanied the transceiver prior to
installation. Only Class 1 laser devices, certifi ed for use in the country of installation by
the cognizant agency are to be utilized in this product.
Statement 1055 –
Do not stare into the laser beam.
Arista PDOC-0002-0
3
7000 Family Quick Start Guide
5
