I. Functions
Note:
the instruction describes all the functions. The users can choose
them according to the actual product function.
On/off:
when the fan is on standby, pressing the button means “on”,
and low-end average wind is set default with
negative ion being
working state; while the fan is in the operating state, pressing the
button means “off”, the fan stops working, and all lights go out, then
the fan is on standby.
Wind speed/shift:
in the working state, wind speed can be regulated
by pressing the button; if the button is pressed repeatedly, air supply
model can be chosen including three models, namely low-
medium-high.
Swing:
in the working state, horizontal automatic air supply can be
realized by pressing the button; but the air supply will be halted when
the button is pressed once again.
Cooling:
in the working state, pressing the button means start the
cooling function, and when pressing it again, the cooling function
ceases. (If the fan is devoid of water, the button is void)
Heating:
While press the “HEAT”button, it turns to be low heating
function;if second press is made, it will be high heating function.
Timing:
in the working state, if the button is pressed, timer can be
activated and if pressed repeatedly can be adjusted as follows:
→
1hour
→
2hours
→
... ...
→
12 hours.
Natural wind:
in the working state, the natural wind can be set by
pressing the button. When pressing it again, the natural wind can be
ceased while the wind speed is turned into low speed. (The wind
speed is void in the natural wind model)
Ionizer:
in the working state, press the button and the ionizer is
turned off; press the button again and the ionizer is turned on.
★★★
Attention:
If water is not sufficient, the pump will immediately stop, the buzzer
goes on and water adding light or cooling light illuminate naturally.
★★★
Attention:
Keep the unit out of children’s reach. Always have an adult to
supervise the children whenever they operate the unit.
Ensure that the power supply is disconnected when moving and
cleaning the unit.
Ensure that the power supply is disconnected when moving and
cleaning the unit.
