ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2157002-INS-RA
•
PAGE 2
Step 1
Remove the factory mud guards on each
side of the Jeep by removing the three bolts
securing each mud guard in place.
Step 4
Remove the four bolts securing the tow
hook on the driver side. The tow hook will
not be reinstalled.
Remove the two large bolts on the passenger
side frame.
Note:
The six large bolts from the
tow hook and the frame will be re-used for the
bumper installation.
Remove the two nuts securing the bracket
to the bumper. Repeat on the passenger side.
Step 2
Remove the side braces on each side
of the Jeep by removing the four bolts
securing each side brace in place.
Step 3
Disconnect the wiring harness for the
license plate light from the body of the Jeep.
Separate the connector from the
wiring harness. A small screw driver
may be needed to separate the connector.
Note:
The bumper does not
accommodate rear backup sensors.
