ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
RA
•
PAGE 4
Step 6
Remove the fog light wiring harness from the
factory bumper. Begin by removing the retainer
clips from the eight bumper mounting studs.
Remove the four bolts securing the beam to
the bumper. Lift the beam from the bumper,
exposing the fog light harness.
Remove the plastic push fasteners securing
the wire harness to the bumper. The harness
will be used on the new bumper.
Note:
To continue the installation, refer to the
installation manual included with your bumper
corners. Refer to the installation manual
supplied with any additional accessories
after the corners have been installed, prior
to mounting the bumper to the vehicle.
With your corners and additional accessories
(if applicable) installed, continue to Step 7 to
complete the bumper installation.
Step 7
Install the factory fog lights into the new
bumper. Be sure to fully engage the plastic
push fasteners on the factory fog light into
the mounting holes on the bumper.
