ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE? • 800.798.0813 • 2074111-INS-RA • PAGE 2
Step 1
Starting on the driver-side, locate
the three mounting locations
underneath the vehicle.
Step 2
Using a utility knife, cut and remove the
tape plug covering the third mounting
point for the front mounting bracket.
Step 3
With help lift the board and align the
front bracket with the mounting locations
and secure it with an M12 hex nut,
lock washer, flat washer and either
two M8 hex bolts, lock washers and
flat washers, or an M10 hex bolt,
flat washer and lock washer.
Note:
On vehicles not equipped with
M8 threaded inserts, align the M10 nut
on the M12 bolt plate with either hole
location on the bracket. Secure using
an M10 hex bolt, lock washer and
flat washer.
Step 4
Repeat steps 2 and 3 to secure the
middle and rear mounting bracket.
Tighten all hardware.
