GB - 7
Handlebar
Unfold upper handlebar until it snaps into position on
the lower handlebar.Tighten the handlebar knobs to
secure.
Discharge Chute
1. Grease discharge chute ring (Figure 1).
2. Remove mounting hardware from studs on top of
engine.
3. Position discharge chute over opening on
housing and chute strap over studs.
4. Secure by fastening to studs with hardware just
removed.
5. Swivel discharge chute from side to side with
control handle to see that it moves freely before
tightening hardware.
Adjust Attachment Clutch Cable
1. Ensure spring is connected into hole in clutch
arm at rear of frame (Figure 2).
2. Ensure clutch cable is routed over the top of the
lower handlebar.
3. Ensure Z bend end of clutch cable is connected
to hole in tab on right side of clutch bail.
Adjust attachment clutch cable per
Attachment
Clutch/Brake Adjustment
in
Service and Adjustments
.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see
Maintenance
Section).
Check Engine Crankcase Oil
IMPORTANT:
Engines on all Sno-Thro models are
shipped with oil in crankcase. Refer to Engine Manual
for proper type oil and crankcase capacity.
Fill Engine Fuel Tank
Refer to Engine Manual for proper type and capacity.
Check Function of All Controls
Ensure unit runs and performs properly. Refer to
Operation
Section.
Run in Attachment Belt
1. Start unit in a well ventilated area according to
Starting and Shut-Off
in
Operation.
2. Engage clutch bail and run attachment belt for
about 15 minutes.
3. Stop unit, wait for all moving parts to stop, and
remove spark plug wire. Adjust according to
Attachment Clutch/Brake Adjustment
in
Service
and Adjustments
.
ASSEMBLY
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to unit.
Read, understand, and follow all safety
practices in Owner/Operator Manual before
beginning.
WARNING:
AVOID INJURY. Read and
understand Assembly/Fuel Safety Rules
before proceeding.
1. Mounting Hardware
2. Discharge Chute
3. Discharge Chute Ring
4. Chute Strap
1
2
4
3
Figure 1
OS1920
WARNING:
FAILURE OF ATTACHMENT
BRAKE could result in death or serious injury.
DS0151
1. Clutch Cable Spring
2. Clutch Arm
Figure 2
1
2
Summary of Contents for Sno-Thro 932500-520
Page 11: ...GB 11 Figure 4 OS1840...
