EN - 12
OPERATE UNIT
1. Rotate discharge chute and move
deflector to desired positions.
2. Select desired speed.
3. Engage attachment clutch.
IMPORTANT:
For best snow-throwing
results, ensure that throttle control knob is set
to the Efficiency or higher position.
NOTICE:
Stop auger when traveling between
work areas.
4. Engage traction drive clutch.
IMPORTANT:
When the unit is turned left or
right, the Auto-Turn
TM
differential
automatically unlocks wheels for easier
turning. On a straight path, the differential
locks both wheels in place for best traction.
Position Drift Cutters
Use drift cutters if snow to be cleared is
higher than auger housing.
1. Loosen wing knobs and move drift cutter
down. See Figure 12.
See Figure 13.
2. Rotate drift cutter forward 180 degrees
until notch engages upper wing knob.
Tighten wing knobs.
3. Repeat on other side.
Clear a Clogged Discharge Chute
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Use the snow clean-out tool to clear the
clog.
3. Return the tool to its storage position on
the auger housing.
STOP THE ENGINE
1. Release traction drive clutch lever.
2. Run auger / impeller for a few minutes to
remove loose or melting snow to prevent
impeller from freezing.
3. Release attachment clutch lever.
4. Turn engine key to stop position and
remove key.
MOVE UNIT MANUALLY
See Figure 14.
• To disengage transmission and move unit
with the engine off, pull the bypass rod
outward.
• Push the rod in to engage the transmission
for normal operation.
Figure 12
WARNING:
NEVER use your
hand to clean out discharge
chute.
Figure 13
Summary of Contents for Professional Sno-Thro Series
Page 31: ......
