GB - 8
NEVER store unit with fuel in fuel tank, inside
a building where any ignition sources are
present such as hot water heaters, space
heaters, or clothes dryers. Allow the engine to
cool before storing in any enclosure.
Shut off fuel and allow engine to cool
completely before storing in closed area or
covering unit.
For extended storage, clean unit thoroughly.
See Engine Manual for proper storage.
Use only attachments or accessories
designed for your unit.
Check components frequently. If worn or
damaged, replace with manufacturer’s
recommended parts.
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
•
Pliers
•
Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
•
Tire Gauge
Unfold Handlebar
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the
second reverse position.
4. Rotate the handlebars into operating
position.
IMPORTANT:
Be careful not to damage cable
spring hooks when rotating handlebars
upward.
5. Install and tighten all hardware on the
handlebar assembly and shift rod.
NOTE:
The handlebar has two height
positions. Adjust the handlebar height to
provide better operator comfort. See
ASSEMBLY
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
WARNING:
Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
Figure 3
1. Sno-Thro
Unit
2. Discharge
Chute
3. Chute Rod
4. Literature
Pack with
Extra Shear
Bolts
OS7020
1. Handlebar
Hardware
2. Shift Rod
Hardware
3. Shift Rod
4. Speed
Selector
Lever
Figure 4
OS7030
