EN - 22
4. With traction clutch disengaged, check
that swing gate tab touches the front edge
of stop hole. See Figure 36.
IMPORTANT:
Swing gate tab MUST touch
stop hole edge. Readjust cable as necessary
until tab touches stop hole edge.
5. Reconnect spark plug wire.
ADJUST TRACK TENSION
Model 920022
1. Check tension by applying pressure to
track between the upper and rear track
rollers. Deflection should be
approximately 9.5 mm (3/8"). See
Figure 37.
2. Adjust tension as needed with track
adjusters. Tighten nut to increase tension;
loosen nut to decrease tension. See
Figure 38.
If unit does not travel correctly, adjust track
tension. See Figure 38.
• If unit pulls to the left, tighten the left track
adjuster.
• If unit pulls to the right, tighten the right
track adjuster.
Figure 36
1. Swing Gate Tab
2. Stop Hole
Figure 37
Apply pressure here.
Figure 38
Adjust here.
